Additional Part Modeling Techniques
Complete the hacksaw blade. Due - 2/8/2017 - Save as xxzzzzzHacksaw
Gear Rack - DUE 2/9/2017 - Save as xxzzzzzGearRack.
Notice the instruction box located below the explanation below.
Notice the instruction box located below the explanation below.
After completing the instructions above. Perform the following actions on the part.
Use the Hole Wizard to place three holes located equidistant from each other and from each end.
Holes should be on the gear tooth face towards the bottom.
The holes should be Counterbore, ANSI Inch, Socket Head Cap Screw , size #10, Normal Fit and Through All. All other properties should be unchecked.
Extrude Cut four holes located equidistant from each other and from each end on the side face.
The side holes should have the following properties: .125" Through All.
Use the Hole Wizard to place three holes located equidistant from each other and from each end.
Holes should be on the gear tooth face towards the bottom.
The holes should be Counterbore, ANSI Inch, Socket Head Cap Screw , size #10, Normal Fit and Through All. All other properties should be unchecked.
Extrude Cut four holes located equidistant from each other and from each end on the side face.
The side holes should have the following properties: .125" Through All.
Plastic Bracket - DUE 2/10/2017
Save as XXZZZZPlasticBracket where xx is your initials and zzzzz is your ID#.
Email the part to me.
Complete the plastic bracket below. Use symmetry as instructed.